RAID Status (RPA1)

Description

The probe reports the status of a redundant disk array (RAID).

Release notes

Show release notes
Version 1.1.0 - General deployment
  • Improvement: Probe will now not be executed on the server if it is not defined on the SMP (M6425)
  • Dependency:
    • SNMP Agent module v3.0.0 or higher
    • RAID Support module v1.0.2+

Version 1.0.0 - General deployment
  • Feature: initial version (M0)
  • Dependency:
    • SNMP Agent module v2.0+
    • RAID Support module v1.0.2+

Resource configuration interface

GUI unavailable.

Resource parameters

This probe has no configurable parameters.

Performance graphs

This probe does not generate any performance graphs.

Alarms

This probe can report following alarm states:

  • WARNING: any of the following conditions:
    • at least one physical disk in the RAID is failing
    • the RAID contains no or only one physical hard drives in 'Online' status
    • no RAID controller is detected
  • UNKNOWN: the status of the RAID could not be verified.

Possible causes

  • physical defect of one of the disks.

Possible consequences

If one of the two disks of a RAID fails:
  • no more protection if the other disk fails.
  • possible degraded performance.

If both disks would fail:
  • the whole SOP will cease to work
  • loss of all data since last backup (today): voicemails, dynamic profile parameters, ...

Possible actions

  • replace the SOP

Copyright © Escaux SA