Incom ICW-1000G (SDU3)

Description

This resource allows to connect and auto-configure a Unidata ICW-1000G WiFi SIP IP Phone.

Release notes

Version 1.1.1 - Early deployment
  • Bugfix: The second proxy were filled in even when disabled for the phone (M16897)
  • Dependency:
    • Unidata/Incom Phone Support v1.6.1

Version 1.0.0 - Early deployment
  • Feature: added support for the "ICW-1000G" phone model (M10681)
  • Dependency:
    • Unidata/Incom Phone Support v1.6.0

Resource configuration interface

GUI unavailable.

Resource configuration parameters

Please note that the 'Unidata Phone Support' module must be installed on your SOP when using this resource

This resource allows an administrator to configure a Unidata ICW-1000G.

  • SIP can reinvite: if this option is set to 'yes', you will instruct the media flow, i.e. the actual voice packets, to be send directly to the destination phone without passing through the SOP. Activating this option can be interesting in large deployments but can result in compatibility problems when establishing a voice communication between IP phones of a different brand. Therefore, the default value is 'no'.
  • QoS - DSCP configuration (More information in Asterisk Module)
    • Diffserv setting for Voice Media (RTP) : Diffserv classification for phone voice outbound IP traffic
    • Diffserv setting for Voice Signaling (SIP) : Diffserv classification for phone signaling (SIP, ...) outbound IP traffic
  • WiFi Settings (up to 4 networks configurations) alert you must configure at least one of them:
    • SSID : If you have a pre-provisioning infrastructure, you can indicate the SSID here if the SSID is not broadcast
    • Security : Select the Security mode
    • Passphrase : Enter the security pass phrase if applies
    • Enable short preamble : Set this to yes to improve roaming capabilities if you are using Motorola (Symbol) access points .
    • Channels to scan : Enter a comma separated value to restrict the scan. example: 1,7,8,11. Leave empty to scan all channels
  • RTP port range: define the RTP port range. Leave empty to keep the default range (UDP 10000 to UDP 20000)
  • Time zone: select your time zone. The phone will automatically adapt its time according to Daylight Saving Time (DST)
  • System Settings
    • Web access password: enter a 6 digits pincode to protect web access to the phone. Only numerical characters are allowed. Leave empty for the default value (000000)
  • Voicemail: Enter the phone number to call for voicemail consultation.

ALERT! Please refer to the following section to connect the handset to any wireless network for the first time: First use quick setup
Copyright © Escaux SA