Administrator Guide: Sangoma Card Support v.3

Introduction

The Sangoma Card Support 3 is based on the Dahdi product (see also Dahdi module).

This version relies on the Dahdi module.

You need to use the DahdiTrunk resource to configure the interfaces.

It will generate the required configuration for Sangoma and for Asterisk.

Some SOP Shell plugins are available in order to provide standard administration tools.

Restrictions

  • Please consult this document "ISDN and analogue connectivity options" in order to have a clear view for ISDN and card integration.
  • Only Baseline 2 is supported.
  • If you want to downgrade to Sangoma Card Support 2, please contact Escaux.

Standard configurations

Standard and common configurations are listed in the documentation for the Dahdi module and Sangoma Card Support modules and DahdiTrunk resource.

Post-installation instructions

1. The Sangoma Card firmware upgrade is a manual operation. Here is the list of firmware version delivered with the latest Sangoma Card Support module:

Card type Firmware version Comment
B500 ???
A101 V40
A102 V40
A104 V45
B700 V35 Without FXS module (not supported with v.3)

To check the currently installed version connect to the SOP Shell
DONE Navigate to: SOP Shell>Diagnostics>Sangoma Cards>Card installation status
Next to each card you will find the version, for example 'V=35'.

The possibility to upgrade the firmware has been introduced in the Sangoma Card Support module v.2.10.0. It is to be done via the SOP Shell menu
DONE Navigate to: Subsystems>Sangoma>Update Sangoma Card Firmware
Follow the instructions on the screen.

Other resources

Copyright © Escaux SA